ASTM B575 Standard Specification for Low-Carbon Nickel-Chromium-Molybdenum, Low-Carbon

ASTM B575 Standard Specification for Low-Carbon Nickel-Chromium-Molybdenum, Low-Carbon Nickel-Chromium-Molybdenum-Copper, Low-Carbon NickelChromium-Molybdenum-Tantalum, and Low-Carbon NickelChromium-Molybdenum-Tungsten Alloy Plate, Sheet, and Strip

1.1 This specifification2 covers plate, sheet, and strip of low-carbon nickel-chromium-molybdenum alloys (UNS N10276, N06022, N06455, N06035, UNS N06058, UNS N06059)*, low-carbon nickel-chromium-molybdenum-copper alloy (UNS N06200), low-carbon nickel-chromium-molybdenum-tantalum alloy (UNS N06210), and low-carbon nickel-chromium-molybdenum-tungsten alloy (UNS N06686) as shown in Table 1, for use in general corrosive service. 

1.2 The following products are covered under this specififi- cation: 

1.2.1 Sheet and Strip—Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright fifinish. 

1.2.2 Plate—Hot or cold rolled, solution annealed, and descaled. 

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identifified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.